UK · EU reference Tyre Pressure

DFSK · Fengon 500 · Recommended

Recommended tyre pressure for a DFSK Fengon 500

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Treat this page as a map of the Fengon 500 band. The legal setpoint is the printed door-pillar label for your VIN. Under-inflation cooks the shoulders of a Fengon 500; over-inflation wears the centre rib and bangs every cat’s eye.

How to set the Fengon 500

  1. Park the DFSK Fengon 500 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Fengon 500 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

DFSK Fengon 500 placard versus sidewall

The tyre-information placard on a DFSK Fengon 500 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Estimated pressure by tyre size (225/45R17 and others)

If your DFSK Fengon 500 no longer wears the OEM diameter, start at the row nearest 225/45R17 or 205/55R16 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
225/45R1735352.412.41241241Sport 17-inch
205/55R1634342.342.34234234Typical mid-compact OEM
215/50R1735352.412.41241241Plus-size 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
185/65R1533332.282.28228228Small / older car
205/60R1634342.342.34234234Taller 16-inch
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact

PSI, bar and kPa

PSI-led conversions for the DFSK Fengon 500 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar38 psi / 2.62 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Fengon 500.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

DFSK notes

No special DFSK exception: the Fengon 500 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the DFSK Fengon 500 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the DFSK sticker and this page disagree, the sticker wins.

Other DFSK models

Questions about this Fengon 500

What is that in bar and kPa for the Fengon 500?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 215/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/45R17, 205/55R16 and 215/50R17 as a planning band.

How often should I check a Fengon 500?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What tyre pressure should a DFSK Fengon 500 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation