UK · EU reference Tyre Pressure

Citroen · C3 Picasso · Bar

Citroen C3 Picasso tyre pressure in bar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this C3 Picasso 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Bar, PSI and kPa

Bar-led conversions around the Citroen C3 Picasso. 2.2-2.4 bar is not “32-35 divided by ten”.

BarPSIkPa
2.0730207
2.2132221
2.2833228
2.3133.5231
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.4550345
4.1460414

Citroen C3 Picasso placard versus sidewall

If the Citroen sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (245/40R18 and others)

Planning cold pressures for sizes often seen on a passenger car. This C3 Picasso sample opens with 245/40R18, then 185/65R15 and 205/55R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
245/40R1836362.482.48248248Wide touring 18-inch
185/65R1533332.282.28228228Small / older car
205/55R1634342.342.34234234Typical mid-compact OEM
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact
225/45R1735352.412.41241241Sport 17-inch
215/55R1634352.342.41234241Slightly wider 16-inch
215/50R1735352.412.41241241Plus-size 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

How to set the C3 Picasso

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep C3 Picasso numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this C3 Picasso.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Citroen notes

No special Citroen exception: the C3 Picasso uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Citroen C3 Picasso usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Citroen sticker and this page disagree, the sticker wins.

Other Citroen models

Questions about this C3 Picasso

Front versus rear on the Citroen C3 Picasso?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What is that in bar and kPa for the C3 Picasso?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

What PSI if I plus-size toward 205/55R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 245/40R18, 185/65R15 and 205/55R16 as a planning band.

Is the sidewall number correct on a Citroen C3 Picasso?

No. Sidewall PSI is a maximum. The C3 Picasso placard is the operating target, near 32-35/32-35 psi.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Handbook: placard · bar vs PSI · front vs rear · cold inflation