UK · EU reference Tyre Pressure

Changhe · X5 · PSI

Changhe X5 tyre PSI

Drivetrain
front-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

PSI is the Imperial reading most UK motorists still see on garage hoses. For the Changhe X5 the catalogue row is 32-35 psi front and 32-35 psi rear. A 10 °C overnight drop takes roughly 1 psi (0.07 bar) off a closed Changhe tyre.

Changhe X5 placard versus sidewall

The tyre-information placard on a Changhe X5 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

PSI, bar and kPa

PSI-led conversions for the Changhe X5 band (32-35 / 32-35).

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Estimated pressure by tyre size (255/50R20 and others)

Planning cold pressures for sizes often seen on a SUV / crossover. This X5 sample opens with 255/50R20, then 235/60R18 and 215/70R16.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
255/50R2037372.552.5525525520-inch plus-size
235/60R1836362.482.48248248Plus-size 18-inch
215/70R1634342.342.34234234Compact crossover
235/65R1735362.412.48241248Mid-size SUV
225/60R1835352.412.41241241Highway CUV
245/60R1836372.482.55248255Heavier CUV
245/55R1936362.482.48248248Low-profile 19-inch
225/65R1735352.412.41241241Very common 17-inch

How to set the X5

  1. Park the Changhe X5 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive X5 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Load notes

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar38 psi / 2.62 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this X5.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Changhe notes

No special Changhe exception: the X5 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Changhe X5 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Changhe sticker and this page disagree, the sticker wins.

Other Changhe models

Questions about this X5

What is that in bar and kPa for the X5?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Is the sidewall number correct on a Changhe X5?

No. Sidewall PSI is a maximum. The X5 placard is the operating target, near 32-35/32-35 psi.

What PSI if I plus-size toward 215/70R16?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 255/50R20, 235/60R18 and 215/70R16 as a planning band.

When does TPMS warn on a Changhe X5?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What tyre pressure should a Changhe X5 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation