UK · EU reference Tyre Pressure

Caravans-Wohnm · Benimar · Bar

Recommended bar for a Caravans-Wohnm Benimar

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
45-65 / 45-65
Bar F / R
3.1-4.5 / 3.1-4.5

bar

3.79 / 3.79

45-65 / 45-65 psi · 379 / 379 kPa

45-65 psi F · 45-65 psi R · 3.1-4.5 / 3.1-4.5 bar · 379/379 kPa

2.3 bar is not 23 psi. On this Benimar 3.1-4.5 bar converts to about 45-65 psi. Use the table, not a guess. Under-inflation cooks the shoulders of a Benimar; over-inflation wears the centre rib and bangs every cat’s eye.

Bar, PSI and kPa

Bar-led conversions around the Caravans-Wohnm Benimar. 3.1-4.5 bar is not “45-65 divided by ten”.

BarPSIkPa
3.4550345
3.7955379
4.1460414
4.4865448

Caravans-Wohnm Benimar placard versus sidewall

If the Caravans-Wohnm sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (215/50R17 and others)

Planning cold pressures for sizes often seen on a passenger car. This Benimar sample opens with 215/50R17, then 225/45R17 and 185/65R15.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R1750503.453.45345345Plus-size 17-inch
225/45R1750503.453.45345345Sport 17-inch
185/65R1550503.453.45345345Small / older car
205/55R1650503.453.45345345Typical mid-compact OEM
245/40R1850503.453.45345345Wide touring 18-inch
195/65R1550503.453.45345345Very common compact
225/40R1850503.453.45345345Low-profile 18-inch
225/50R1750503.453.45345345Touring 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only50 psi / 3.45 bar50 psi / 3.45 bar
Full occupancy50 psi / 3.45 bar50 psi / 3.45 bar
Motorway + luggage50 psi / 3.45 bar50 psi / 3.45 bar

How to set the Benimar

  1. Park the Caravans-Wohnm Benimar for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 45-65 psi / 3.1-4.5 bar front and 45-65 psi / 3.1-4.5 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a front-wheel drive Benimar is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 55 psi as a 20 °C baseline for this Benimar.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)52 psi3.59 bar359 kPaGauge reads low; do not overfill once warm
0 °C53 psi3.65 bar365 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)54 psi3.72 bar372 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)55 psi3.79 bar379 kPaBaseline
30 °C57 psi3.93 bar393 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)58 psi4 bar400 kPaDo not bleed a hot tyre

Caravans-Wohnm notes

No special Caravans-Wohnm exception: the Benimar uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Caravans-Wohnm Benimar usually follows the higher axle (often the rear, near 45-65 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the Caravans-Wohnm sticker and this page disagree, the sticker wins.

Other Caravans-Wohnm models

Questions about this Benimar

What is that in bar and kPa for the Benimar?

Mid-points are about 3.79 bar (379 kPa) front and 3.79 bar (379 kPa) rear.

Front versus rear on the Caravans-Wohnm Benimar?

This row is 45-65 F / 45-65 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

How often should I check a Benimar?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What tyre pressure should a Caravans-Wohnm Benimar use?

Catalogue reference is 45-65 psi front and 45-65 psi rear (3.1-4.5 / 3.1-4.5 bar), cold. Confirm on the door-pillar placard.

Handbook: placard · bar vs PSI · front vs rear · cold inflation