UK · EU reference Tyre Pressure

Cadillac · CT6 · Bar

Cadillac CT6 bar chart (2.2-2.4 / 2.2-2.4)

Drivetrain
front-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

2.3 bar is not 23 psi. On this CT6 2.2-2.4 bar converts to about 32-35 psi. Use the table, not a guess. Under-inflation cooks the shoulders of a CT6; over-inflation wears the centre rib and bangs every cat’s eye.

Bar, PSI and kPa

Bar-led conversions around the Cadillac CT6. 2.2-2.4 bar is not “32-35 divided by ten”.

BarPSIkPa
2.0730207
2.2132221
2.2833228
2.3133.5231
2.4135241
2.4836248
2.6238262
2.7640276
3.0344303
3.4550345
4.1460414

Cadillac CT6 placard versus sidewall

If the Cadillac sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (185/65R15 and others)

185/65R15 is the first planning size here. 225/50R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
185/65R1533332.282.28228228Small / older car
225/45R1735352.412.41241241Sport 17-inch
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact
215/55R1634352.342.41234241Slightly wider 16-inch
205/55R1634342.342.34234234Typical mid-compact OEM
245/40R1836362.482.48248248Wide touring 18-inch
225/40R1836362.482.48248248Low-profile 18-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar38 psi / 2.62 bar

How to set the CT6

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep CT6 numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this CT6.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Cadillac notes

No special Cadillac exception: the CT6 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Cadillac CT6 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Keep the Cadillac CT6 on the printed band; use 185/65R15 and 225/50R17 only as a map for non-OEM wheels.

Other Cadillac models

Questions about this CT6

What tyre pressure should a Cadillac CT6 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

How often should I check a CT6?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What PSI if I plus-size toward 225/50R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 185/65R15, 225/45R17 and 225/50R17 as a planning band.

Is the sidewall number correct on a Cadillac CT6?

No. Sidewall PSI is a maximum. The CT6 placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation