Borgward · Hansa 2000 · Bar

Borgward Hansa 2000 tyre pressure in bar

Drivetrain: front-wheel drive
Body: passenger car
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

bar

2.31 / 2.31

32-35 / 32-35 psi · 231 / 231 kPa

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

European and UK handbooks usually quote bar. The Borgward Hansa 2000 catalogue is 2.2-2.4 bar front and 2.2-2.4 bar rear (midpoint 2.31 / 2.31). TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target.

Bar, PSI and kPa

Bar-led conversions around the Borgward Hansa 2000. 2.2-2.4 bar is not “32-35 divided by ten”.

Bar	PSI	kPa
2.07	30	207
2.21	32	221
2.28	33	228
2.31	33.5	231
2.41	35	241
2.48	36	248
2.62	38	262
2.76	40	276
3.03	44	303
3.45	50	345
4.14	60	414

Borgward Hansa 2000 placard versus sidewall

If the Borgward sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (185/65R15 and others)

185/65R15 is the first planning size here. 225/45R17 is usually the plus-size or LT step. Keep load index at or above original equipment.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
185/65R15	33	33	2.28	2.28	228	228	Small / older car
205/60R16	34	34	2.34	2.34	234	234	Taller 16-inch
225/45R17	35	35	2.41	2.41	241	241	Sport 17-inch
195/65R15	34	34	2.34	2.34	234	234	Very common compact
245/40R18	36	36	2.48	2.48	248	248	Wide touring 18-inch
215/50R17	35	35	2.41	2.41	241	241	Plus-size 17-inch
215/55R16	34	35	2.34	2.41	234	241	Slightly wider 16-inch
225/50R17	35	35	2.41	2.41	241	241	Touring 17-inch

Load notes

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	36 psi / 2.48 bar

How to set the Hansa 2000

Measure before the school run, not after the M25.
Write LF / RF / RR / RL. Do not keep Hansa 2000 numbers in your head.
Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
If one corner is 4 psi down, hunt for a nail before you blame the weather.
Log date, ambient temperature and the four readings.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Hansa 2000.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

Borgward notes

No special Borgward exception: the Hansa 2000 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the Borgward Hansa 2000 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

A cheap gauge and a monthly habit will do more for this Hansa 2000 than nitrogen upsells.

Other Borgward models

P100 Arabella Hansa 400/500 BX5 Hansa 2400 Hansa 1100 Hansa 1700 Hansa 1500

Questions about this Hansa 2000

What tyre pressure should a Borgward Hansa 2000 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

How often should I check a Hansa 2000?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

What is that in bar and kPa for the Hansa 2000?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

When does TPMS warn on a Borgward Hansa 2000?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 185/65R15, 205/60R16 and 225/45R17 as a planning band.

Handbook: placard · bar vs PSI · front vs rear · cold inflation