BAIC · Senova X35 · Recommended

BAIC Senova X35 recommended cold inflation

Drivetrain: front-wheel drive
Body: SUV / crossover
PSI F / R: 32-35 / 32-35
Bar F / R: 2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

Treat this page as a map of the Senova X35 band. The legal setpoint is the printed door-pillar label for your VIN. Under-inflation cooks the shoulders of a Senova X35; over-inflation wears the centre rib and bangs every cat’s eye.

How to set the Senova X35

Park the BAIC Senova X35 for at least three hours (cold tyres).
Use a calibrated gauge, not the only meter on a forecourt hose.
Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
Recheck all four. A 2 psi miss on a front-wheel drive Senova X35 is enough to feel a pull.
Refit valve caps and reset TPMS if the handbook asks for a relearn.

BAIC Senova X35 placard versus sidewall

If the BAIC sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

Estimated pressure by tyre size (225/65R17 and others)

Planning cold pressures for sizes often seen on a SUV / crossover. This Senova X35 sample opens with 225/65R17, then 255/50R20 and 235/65R17.

Tyre size	Front PSI	Rear PSI	Front bar	Rear bar	Front kPa	Rear kPa	Note
225/65R17	35	35	2.41	2.41	241	241	Very common 17-inch
255/50R20	37	37	2.55	2.55	255	255	20-inch plus-size
235/65R17	35	36	2.41	2.48	241	248	Mid-size SUV
245/55R19	36	36	2.48	2.48	248	248	Low-profile 19-inch
215/70R16	34	34	2.34	2.34	234	234	Compact crossover
245/60R18	36	37	2.48	2.55	248	255	Heavier CUV
235/60R18	36	36	2.48	2.48	248	248	Plus-size 18-inch
225/60R18	35	35	2.41	2.41	241	241	Highway CUV

PSI, bar and kPa

PSI-led conversions for the BAIC Senova X35 band (32-35 / 32-35).

PSI	Bar	kPa
30	2.07	207
32	2.21	221
33	2.28	228
33.5	2.31	231
35	2.41	241
36	2.48	248
38	2.62	262
40	2.76	276
44	3.03	303
50	3.45	345
60	4.14	414

Pressure against load

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

Condition	Front (est.)	Rear (est.)
Driver only	34 psi / 2.34 bar	34 psi / 2.34 bar
Full occupancy	35 psi / 2.41 bar	36 psi / 2.48 bar
Motorway + luggage	36 psi / 2.48 bar	37 psi / 2.55 bar

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Senova X35.

Ambient	Gauge (front mid)	Bar	kPa	Note
−5 °C (hard frost)	31 psi	2.14 bar	214 kPa	Gauge reads low; do not overfill once warm
0 °C	32 psi	2.21 bar	221 kPa	Gauge reads low; do not overfill once warm
8 °C (UK winter morning)	33 psi	2.28 bar	228 kPa	Gauge reads low; do not overfill once warm
20 °C (set cold here)	34 psi	2.34 bar	234 kPa	Baseline
30 °C	36 psi	2.48 bar	248 kPa	Do not bleed a hot tyre
38 °C (heatwave tarmac)	37 psi	2.55 bar	255 kPa	Do not bleed a hot tyre

BAIC notes

No special BAIC exception: the Senova X35 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Spare and inflator kit

A matching full-size spare on the BAIC Senova X35 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

If the BAIC sticker and this page disagree, the sticker wins.

Other BAIC models

D20 Senova Zhixing Senova X55 Beijing X75 BJ30 B40 BJ80 Senova X25

Questions about this Senova X35

When does TPMS warn on a BAIC Senova X35?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Front versus rear on the BAIC Senova X35?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

What tyre pressure should a BAIC Senova X35 use?

Catalogue reference is 32-35 psi front and 32-35 psi rear (2.2-2.4 / 2.2-2.4 bar), cold. Confirm on the door-pillar placard.

What PSI if I plus-size toward 235/65R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 225/65R17, 255/50R20 and 235/65R17 as a planning band.

How often should I check a Senova X35?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Handbook: placard · bar vs PSI · front vs rear · cold inflation