UK · EU reference Tyre Pressure

Audi · Q7 · Overview

Audi Q7: 2.2-2.4 bar / 32-35 psi

Drivetrain
all-wheel drive
Body
SUV / crossover
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

This all-wheel drive SUV / crossover is filed here with a working range of 32-35/32-35 psi. The pillar sticker on your VIN still overrides the website. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Keep side-to-side spread inside about 2 psi so the all-wheel drive hardware is not working on a radius mismatch.

Spare and inflator kit

A matching full-size spare on the Audi Q7 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Estimated pressure by tyre size (235/65R17 and others)

If your Audi Q7 no longer wears the OEM diameter, start at the row nearest 235/65R17 or 225/65R17 and confirm with the tyre maker’s load table.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
235/65R1735362.412.48241248Mid-size SUV
225/65R1735352.412.41241241Very common 17-inch
215/70R1634342.342.34234234Compact crossover
245/60R1836372.482.55248255Heavier CUV
225/60R1835352.412.41241241Highway CUV
235/60R1836362.482.48248248Plus-size 18-inch
255/50R2037372.552.5525525520-inch plus-size
245/55R1936362.482.48248248Low-profile 19-inch

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this Q7.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

Audi notes

No special Audi exception: the Q7 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

Pressure against load

Load moves the rear of a SUV / crossover first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy35 psi / 2.41 bar36 psi / 2.48 bar
Motorway + luggage36 psi / 2.48 bar37 psi / 2.55 bar

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the Q7: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

Audi Q7 placard versus sidewall

If the Audi sticker is painted over, the handbook is next. This website is a map, not a replacement VIN label.

How to set the Q7

  1. Park the Audi Q7 for at least three hours (cold tyres).
  2. Use a calibrated gauge, not the only meter on a forecourt hose.
  3. Set the placard for that axle — about 32-35 psi / 2.2-2.4 bar front and 32-35 psi / 2.2-2.4 bar rear on this catalogue row.
  4. Recheck all four. A 2 psi miss on a all-wheel drive Q7 is enough to feel a pull.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Keep the Audi Q7 on the printed band; use 235/65R17 and 215/70R16 only as a map for non-OEM wheels.

Other Audi models

Questions about this Q7

Front versus rear on the Audi Q7?

This row is 32-35 F / 32-35 R. Even when they match, a laden rear can justify a higher number if the sticker prints one.

When does TPMS warn on a Audi Q7?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

What is that in bar and kPa for the Q7?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

Is the sidewall number correct on a Audi Q7?

No. Sidewall PSI is a maximum. The Q7 placard is the operating target, near 32-35/32-35 psi.

Handbook: placard · bar vs PSI · front vs rear · cold inflation