UK · EU reference Tyre Pressure

Audi · 100 · Overview

Tyre pressure chart for the Audi 100

Drivetrain
all-wheel drive
Body
passenger car
PSI F / R
32-35 / 32-35
Bar F / R
2.2-2.4 / 2.2-2.4

psi

34 / 34

Catalogue mid-points, front / rear · 2.2-2.4 / 2.2-2.4 bar

32-35 psi F · 32-35 psi R · 2.2-2.4 / 2.2-2.4 bar · 231/231 kPa

The Audi 100 catalogue band is 32-35 psi front and 32-35 psi rear — 2.2-2.4 / 2.2-2.4 bar, or about 231 / 231 kPa — measured cold. TPMS typically warns near 25 psi (about 25% below target). That is already a soft tyre, not a fill target. Keep side-to-side spread inside about 2 psi so the all-wheel drive hardware is not working on a radius mismatch.

Estimated pressure by tyre size (215/50R17 and others)

Planning cold pressures for sizes often seen on a passenger car. This 100 sample opens with 215/50R17, then 205/60R16 and 225/45R17.

Tyre sizeFront PSIRear PSIFront barRear barFront kPaRear kPaNote
215/50R1735352.412.41241241Plus-size 17-inch
205/60R1634342.342.34234234Taller 16-inch
225/45R1735352.412.41241241Sport 17-inch
225/40R1836362.482.48248248Low-profile 18-inch
215/55R1634352.342.41234241Slightly wider 16-inch
225/50R1735352.412.41241241Touring 17-inch
195/65R1534342.342.34234234Very common compact
185/65R1533332.282.28228228Small / older car

Temperature and a cold gauge

Roughly 1 psi per 5–6 °C. The table uses 34 psi as a 20 °C baseline for this 100.

AmbientGauge (front mid)BarkPaNote
−5 °C (hard frost)31 psi2.14 bar214 kPaGauge reads low; do not overfill once warm
0 °C32 psi2.21 bar221 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)34 psi2.34 bar234 kPaBaseline
30 °C36 psi2.48 bar248 kPaDo not bleed a hot tyre
38 °C (heatwave tarmac)37 psi2.55 bar255 kPaDo not bleed a hot tyre

PSI, bar and kPa

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Mid-points on the 100: 34 psi = 2.31 bar = 231 kPa.

PSIBarkPa
302.07207
322.21221
332.28228
33.52.31231
352.41241
362.48248
382.62262
402.76276
443.03303
503.45345
604.14414

How to set the 100

  1. Measure before the school run, not after the M25.
  2. Write LF / RF / RR / RL. Do not keep 100 numbers in your head.
  3. Add air in short bursts toward 34 psi (2.31 bar) front and 34 psi rear.
  4. If one corner is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Audi 100 placard versus sidewall

The tyre-information placard on a Audi 100 sits on the driver’s door pillar (sometimes the fuel-filler flap). Catalogue figures here are a general band: 32-35 / 32-35 psi.

Spare and inflator kit

A matching full-size spare on the Audi 100 usually follows the higher axle (often the rear, near 32-35 psi). A space-saver is commonly 60 psi / 4.1 bar — read that tyre’s own sidewall. An inflator kit is not a spare; check the sealant date.

Pressure against load

Load moves the rear of a passenger car first. If the factory placard already has a “laden” column, use that instead of these sketches.

ConditionFront (est.)Rear (est.)
Driver only34 psi / 2.34 bar34 psi / 2.34 bar
Full occupancy34 psi / 2.34 bar35 psi / 2.41 bar
Motorway + luggage35 psi / 2.41 bar38 psi / 2.62 bar

Audi notes

No special Audi exception: the 100 uses the door-pillar placard. Size estimates on this page only help if you have left the original load index behind.

If the Audi sticker and this page disagree, the sticker wins.

Other Audi models

Questions about this 100

Is the sidewall number correct on a Audi 100?

No. Sidewall PSI is a maximum. The 100 placard is the operating target, near 32-35/32-35 psi.

When does TPMS warn on a Audi 100?

Direct TPMS typically flags about 25% below placard — near 25 psi on this row. Fill to the sticker, not to the lamp.

What PSI if I plus-size toward 225/45R17?

Keep load index at or above OEM. Low-profile sizes usually stay at or slightly above the placard. Use 215/50R17, 205/60R16 and 225/45R17 as a planning band.

What is that in bar and kPa for the 100?

Mid-points are about 2.31 bar (231 kPa) front and 2.31 bar (231 kPa) rear.

How often should I check a 100?

Monthly, before a long trip, and after a 10 °C weather swing. Include a full-size spare.

Handbook: placard · bar vs PSI · front vs rear · cold inflation