UK · EU reference Tyre Pressure

255/45R19 · SUV / crossover · kPa

255/45R19 tyre pressure in kPa

Size
255/45R19
Class
SUV / crossover
Planning PSI
36
Planning bar
2.48

kPa

248

2.48 bar · 36 psi · 100 kPa = 1 bar

255/45R19 · 36 psi · 2.48 bar · 248 kPa — estimates. Placard wins.

If the gauge only speaks kPa, 248 kPa is the sketch for this SUV / crossover size. Fine-tune to the vehicle that actually wears 255/45R19. Under-inflation cooks the shoulders of a 255/45R19; over-inflation wears the centre rib and bangs every cat’s eye.

kPa, bar and PSI

1 bar ≈ 14.5 psi; 1 psi ≈ 6.89 kPa. Planning midpoint for 255/45R19: 36 psi = 2.48 bar = 248 kPa.

kPaBarPSI
2212.2132
2282.2833
2342.3434
2412.4135
2482.4836
2552.5537
2622.6238
2692.6939
2762.7640
2832.8341
2902.9042
2962.9643
3033.0344
3103.1045
3173.1746
3243.2447
3313.3148

Estimated 255/45R19 pressure by load

These 255/45R19 load steps are ± a few PSI from 36. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen36 psi / 2.48 bar / 248 kPa38 psi / 2.62 bar / 262 kPa
Typical occupancy36 psi / 2.48 bar / 248 kPa39 psi / 2.69 bar / 269 kPa
Motorway + luggage (sketch)37 psi / 2.55 bar / 255 kPa40 psi / 2.76 bar / 276 kPa

What 255/45R19 means

255/45R19 means a 255 millimetre section width, a sidewall that is 45 percent of that width, on a 19-inch rim. The R is radial construction.

19-inch SUV plus-size. Rim diameter 19 in; section 255 mm. Estimates on this page assume a typical load index for the SUV / crossover class.

Placard versus sidewall

If a forum says “all 255/45R19 run 36 psi”, ignore it. A Qashqai and a Golf can share a size and not share a sticker.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 36 psi as a 20 °C baseline for 255/45R19.

AmbientGaugeBarkPaNote
−5 °C (hard frost)33 psi2.28 bar228 kPaGauge reads low; do not overfill once warm
0 °C34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)36 psi2.48 bar248 kPaBaseline for this size sketch
30 °C38 psi2.62 bar262 kPaDo not bleed a hot 255/45R19
38 °C (heatwave tarmac)39 psi2.69 bar269 kPaDo not bleed a hot 255/45R19

How to set 255/45R19

  1. Measure before the school run, not after the motorway.
  2. Write LF / RF / RR / RL. Do not keep 255/45R19 numbers in your head.
  3. Add air in short bursts toward the placard, using 36 psi only as a map.
  4. If one 255/45R19 is 4 psi down, hunt for a nail before you blame the weather.
  5. Log date, ambient temperature and the four readings.

Cars often seen on 255/45R19

These catalogue models are often seen on 255/45R19 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

A cheap gauge and a monthly habit will do more for a set of 255/45R19 than nitrogen upsells.

Questions about 255/45R19

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is the sidewall number correct for 255/45R19?

No. Sidewall PSI or kPa is a maximum for the carcass. Operating pressure is the door-pillar placard.

Can I run 255/45R19 at a lower pressure for comfort?

Not as a habit. A soft 255/45R19 cooks the shoulders and dulls steering. Keep load index and stay on the placard.

What PSI should 255/45R19 tyres be?

A SUV / crossover planning figure is about 36 psi cold (2.48 bar / 248 kPa). Confirm on the vehicle placard — two cars can share 255/45R19 and not share a sticker.

What is 255/45R19 in bar?

36 psi is 2.48 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

Handbook: placard · bar vs PSI · cold inflation · all sizes