UK · EU reference Tyre Pressure

245/35R19 · passenger car · Bar

245/35R19 tyre pressure in bar

Size
245/35R19
Class
passenger car
Planning PSI
37
Planning bar
2.55

bar

2.55

37 psi · 255 kPa · not a second factory sticker

245/35R19 · 37 psi · 2.55 bar · 255 kPa — estimates. Placard wins.

European stickers print bar. 245/35R19 often sits near 2.55 bar on a passenger car (37 psi / 255 kPa). 2.55 bar is not “37 divided by ten”. TPMS typically warns near 28 psi (about 25% below a 37 psi target). That is already a soft tyre. Low-profile {sz} does not want a “softer” pressure to recover ride. Stay at or slightly above the car’s original placard if load index is kept.

Bar, PSI and kPa

Convert around the 245/35R19 band. 2.55 bar is about 37 psi — not 23, not 33 unless the maths says so.

BarPSIkPa
2.2833228
2.3434234
2.4135241
2.4836248
2.5537255
2.6238262
2.6939269
2.7640276
2.8341283
2.9042290
2.9643296
3.0344303
3.1045310
3.1746317
3.2447324
3.3148331
3.3849338

Estimated 245/35R19 pressure by load

These 245/35R19 load steps are ± a few PSI from 37. They are not a licence to ignore a printed second column on a van or estate.

ConditionFront (est.)Rear (est.)
Driver only / unladen37 psi / 2.55 bar / 255 kPa37 psi / 2.55 bar / 255 kPa
Typical occupancy37 psi / 2.55 bar / 255 kPa38 psi / 2.62 bar / 262 kPa
Motorway + luggage (sketch)38 psi / 2.62 bar / 262 kPa39 psi / 2.69 bar / 269 kPa

Placard versus sidewall

The sidewall of a 245/35R19 may say 51 psi or 350 kPa. That is a carcass maximum. Operating pressure is the tyre-information placard on the driver’s door pillar.

What 245/35R19 means

A 245/35R19 on a passenger car is a geometry. Two cars can share the size and disagree on PSI because mass and axle split differ.

19-inch sport saloon. Rim diameter 19 in; section 245 mm. Estimates on this page assume a typical load index for the passenger car class.

Cars often seen on 245/35R19

These catalogue models are often seen on 245/35R19 or a close OEM neighbour. Open the vehicle chart for axle-specific PSI and bar.

How to set 245/35R19

  1. Park so the 245/35R19 tyres are cold (three hours, or less than about a mile).
  2. Read the door-pillar placard for that car — not the 245/35R19 sidewall maximum.
  3. If the sticker is missing, 37 psi / 2.55 bar is only a passenger car planning figure for this size.
  4. Set all four with a calibrated gauge. A 3 psi miss on one corner shows up as a wander.
  5. Refit valve caps and reset TPMS if the handbook asks for a relearn.

Temperature drift

Roughly 1 psi per 5–6 °C. The table uses 37 psi as a 20 °C baseline for 245/35R19.

AmbientGaugeBarkPaNote
−5 °C (hard frost)34 psi2.34 bar234 kPaGauge reads low; do not overfill once warm
0 °C35 psi2.41 bar241 kPaGauge reads low; do not overfill once warm
8 °C (UK winter morning)36 psi2.48 bar248 kPaGauge reads low; do not overfill once warm
20 °C (set cold here)37 psi2.55 bar255 kPaBaseline for this size sketch
30 °C39 psi2.69 bar269 kPaDo not bleed a hot 245/35R19
38 °C (heatwave tarmac)40 psi2.76 bar276 kPaDo not bleed a hot 245/35R19

If the door sticker and this 245/35R19 page disagree, the sticker wins.

Questions about 245/35R19

Should I bleed pressure after a motorway run?

No. Heat raises the gauge. Set cold only. Bleeding a hot tyre leaves it low the next morning.

Is 245/35R19 the same as a plus-size swap?

Only if that is the size you fitted. Overall diameter should stay close to OEM. Pressure still follows the car, with load index at or above original.

What is 245/35R19 in bar?

37 psi is 2.55 bar. Add a tenth of a bar if the placard’s laden column is higher, which is common on vans that wear this size.

What is 245/35R19 in kPa?

255 kPa is the planning midpoint (100 kPa = 1 bar). 262 kPa is one PSI higher.

What PSI should 245/35R19 tyres be?

A passenger car planning figure is about 37 psi cold (2.55 bar / 255 kPa). Confirm on the vehicle placard — two cars can share 245/35R19 and not share a sticker.

Handbook: placard · bar vs PSI · cold inflation · all sizes